On 19-1-2016 2:30, Vishnu Patekar wrote: > Hello Arend, > > I've A83T BPI-m3 board, which includes AP6212(brcm43430). I'm trying > to make it work for mainline linux and brcm driver. > > After enabling mmc1, It could read vendor: 0x02d0 device: 0xa9a6. from > /sys/bus/mmc/devices/mmc1:0001/mmc1:0001:1 > > BRCM driver loads the firmware files, however, it gives below errors > and wlan0 is not available: > > dmesg | grep brcm > [ 1.187459] brcmfmac: brcmf_of_probe: interrupt could not be mapped
Not sure whether this might cause an issue. Could be a devicetree issue. Regards, Arend > [ 1.194419] brcmfmac: F1 signature read @0x18000000=0x1530a9a6 > [ 1.197807] brcmfmac: brcmf_sdio_drivestrengthinit: No SDIO Drive > strength init done for chip 43430 rev 0 pmurev 24 > [ 2.310138] brcmfmac: brcmf_sdio_htclk: HT Avail timeout (1000000): > clkctl 0x50 > [ 3.319433] brcmfmac: brcmf_sdio_htclk: HT Avail timeout (1000000): > clkctl 0x50 > [ 4.349022] brcmfmac: brcmf_sdio_htclk: HT Avail timeout (1000000): > clkctl 0x50 > > > There are no brcm43430 firmware files at > http://git.kernel.org/cgit/linux/kernel/git/firmware/linux-firmware.git/tree/brcm > So, used firmware: > https://github.com/RPi-Distro/firmware-nonfree/tree/master/brcm80211/brcm/brcmfmac43430-sdio.bin > and .txt. > > Could you please help me in this regard ? > > > Regards, > Vishnu > -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
