On 14 April 2016 at 12:53, Juan Carlos Barrientos <[email protected]> wrote: > Thanks!! i would like to run accelerometer stk8313 and sound, is any kernel > module ? Hi Juan,
good effort on what you've done with the tablet. There is no sound driver yet for the sun6i(a31) platform on mainline....I've started looking at it but I've not managed to get any sound out of my device. I need to check the mux settings for the DAC and was looking to have a look at the legacy setup to compare. There is also some DMA patches which are required. If you're desperate for audio then it's most likely only available via a usb device for now. BR, CK > > I have do a web page fot colorfly e708. I will incorporate news for thius > tablet ---> https://linux-sunxi.org/Colorfly_e708q1 > > > El jueves, 14 de abril de 2016, 10:47:58 (UTC+2), Алексей Мамлин escribió: >> >> четверг, 14 апреля 2016 г., 9:07:42 UTC+3 пользователь Juan Carlos >> Barrientos написал: >>> >>> Hello >>> >>> In my case this is the tablet colorfly,s hardware: >>> >>> -AXP221s D3108CB 6631 (Power Management IC) >>> -RTL 8188ETV (wifi)- In kernel select: >>> 1-Networking support -->Wireless >>> 2-Device drivers -->Staging drivers--> RTL8188 >>> -Goofix 911 (touchscreen): I have modify suni6-a31s-colorfly-e708.dts >>> (U-boot,) in order to the goodix gt911 work. Netx calibrate file: >>> -/usr/share/X11/xorg.conf.d/10-evdev.conf : >>> Section "InputClass" >>> Identifier "calibration" >>> MatchProduct "Goodix Capacitive TouchScreen" >>> Option "Calibration" "4 1200 800 -1" >>> Option "SwapAxes" "1" >> >> >> Axes can be swapped by driver, use touchscreen-swapped-x-y; property in >> touchscreen node of dts. >> >>> >>> >>> EndSection. >>> >>> -XT1208- Voltage regulator >>> -I29F64G08AAMEI: Internal flash memory 8GB >>> -ELPIA J4216BBBG-GN-F (HAY DOS ) DDR3 SDRAM 1GB (2x 512MB) >>> -CHIP??2011M 130927¿¿¿???? >>> >>> >>> Basicaly i have two hardwarware element,s that don,t work: >>> >>> -Amlogic STK8313 3121D 07B37: Accelerometer, i have seen stk8312.c file >>> but this driver has I2C 2x3D, stk8312 works on i2c 0x22 >>> kernel/linux-4.6-rc2/drivers/iio/accel ¿any idea how to use or port 8313 >>> module? >>> >>> -Sound: I don,t kwon how works audio codec >>> >>> Thanks >>> J.C > > -- > You received this message because you are subscribed to the Google Groups > "linux-sunxi" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
