Arend Van Spriel <[email protected]> writes: >>> Typical wifi devices will have some sort of non volatile storage >>> on board to not only store the ethernet(mac) address, but also >>> to contain e.g. info about the antenna gain so that the firmware >>> and/or the driver can take the antenna gain into account and ensure >>> that they never exceed the maximum allowed broadcast strength. >>> >>> However on some embedded devices there is no non-volatile storage >>> for the wifi (for cost reasons) and instead this configuration info >>> (which is board / pcb specific) is loaded in the form of a >>> file which contains the contents which would normally be in the >>> non-volatile storage. >>> >>> Since we are dealing with a per-board config-file here, which is >>> loaded from the os filesystem we really need to specify a basename >>> here as the list of possible boards is endless, so we cannot >>> have a lookup table in the driver. > > As a note: For BT Marcel was playing with the idea of having a lookup > table on the file system which would be loaded by the driver.
In ath10k we have a similar problem but in our case we can use the subsystem id to detect what board file to use, so it's not exactly same as yours. In our board-2.bin we have identifiers like this from which ath10k selects the correct board file: bus=pci,vendor=168c,device=003e,subsystem-vendor=168c,subsystem-device=334e bus=pci,vendor=168c,device=003e,subsystem-vendor=168c,subsystem-device=3360 bus=pci,vendor=168c,device=003e,subsystem-vendor=168c,subsystem-device=3361 -- Kalle Valo -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
