Hello, On 30 June 2016 at 16:44, Ondřej Jirman <[email protected]> wrote: > Hi, > > hopefuly, it was the NPE that I fixed. It was specifically in the H3 usb > phy code path for phy0. So I believe it was untested, > because I didn't find any dts file that would use phy0. >
This WorksForMe(TM). I can ssh into OPi One over usb gadget. This gives way better terminal capability than serial uart. Maybe squashing the two code patches or using patch order marks would be helpful here. When ordered by hash the first two patches are reversed. Thanks Michal > > On 30.6.2016 07:17, [email protected] wrote: >> Nice work. >> Sure i will try your path, last time i tried otg i had kernel exception when >> loading musb driver. >> I would like setup usb otg in device mode as g_ether or cdrom drive >> emulation to loading bootable iso with gpio sw for iso selection yes i dream >> :) >> >> But for now I try to translate audio codec driver from kernel 3.4,,,removing >> lot of config from fex file, remove undocumented R-PRCM (0x01f01400) >> read/Write (seem to be configuration area for current setting to restore >> after a reboot, not vital..), setup PLL2 (audio_pll) directly in driver >> since there isn't no clk driver PLL2 for now (I think it's related to I2S >> driver, and it's a complex clock with multi factor to adjust PLL frequency). >> For now i just configure it at 24.57Mhz/22.57Mhz and i have succes to have >> something in /sys/class/device/sunxi_codec/ and /sunxi-pcm-codec/, no kernel >> exception but no sound card available :( >> When i see in sun4i audio driver, there is lot of new code to create card in >> /dev/snd/... >> It's seem I'm lost deeply in nowhere for now, but I will try your work for >> sure (just one source of kernel opps at the same time!). >> > > -- > You received this message because you are subscribed to the Google Groups > "linux-sunxi" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
