在 2017-10-31 15:57，Jagan Teki 写道：
On Tue, Oct 31, 2017 at 5:06 AM, Icenowy Zheng <[email protected]> wrote:
Some H5 boards are designed to start at 1.1V CPUx voltage (e.g. Nano
Pi
NEO2), which may not work properly at 1008MHz if the chip's quality is
not so good.
Lower the default CPUx frequency of H5 to 816MHz.
Signed-off-by: Icenowy Zheng <[email protected]>
---
arch/arm/mach-sunxi/Kconfig | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm/mach-sunxi/Kconfig b/arch/arm/mach-sunxi/Kconfig
index 09cfec6f57..1fededd0a3 100644
--- a/arch/arm/mach-sunxi/Kconfig
+++ b/arch/arm/mach-sunxi/Kconfig
@@ -397,9 +397,9 @@ config SYS_CLK_FREQ
default 1008000000 if MACH_SUN5I
default 1008000000 if MACH_SUN6I
default 912000000 if MACH_SUN7I
+ default 816000000 if MACH_SUN50I || MACH_SUN50I_H5
default 1008000000 if MACH_SUN8I
Even orangepi pc2 has 1.1v after power-on and it's work fine [1] did
you find an issue with neo2?
Yes, the boot process randomly hang at SPL stage -- but when it enters
ATF it will run smoothly as the ATF will re-configure CPUx frequency
to 816MHz.
According to the official operating point table [2], 1008MHz is bound
to 1.2V, and 816MHz is bound to 1.1V.
Allwinner chips usually have not-so-good quality control to reach the
low price, and different chips may work differently in situations
that is beyond the official the OPP table.
[2]
https://github.com/OrangePiLibra/OrangePi_H5SDK/blob/master/external/sys_config.fex#L1367
[1] http://linux-sunxi.org/Xunlong_Orange_Pi_PC_2#CPU_clock_speed_limit
thanks!
--
You received this message because you are subscribed to the Google Groups
"linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
