于 2017年10月31日 GMT+08:00 下午4:53:57, Jagan Teki <jagannadh.t...@gmail.com>
写到:
On Tue, Oct 31, 2017 at 1:35 PM, <icen...@aosc.io> wrote:
在 2017-10-31 15:57，Jagan Teki 写道：
On Tue, Oct 31, 2017 at 5:06 AM, Icenowy Zheng <icen...@aosc.io>
wrote:
Some H5 boards are designed to start at 1.1V CPUx voltage (e.g.
Nano Pi
NEO2), which may not work properly at 1008MHz if the chip's quality
is
not so good.
Lower the default CPUx frequency of H5 to 816MHz.
Signed-off-by: Icenowy Zheng <icen...@aosc.io>
---
arch/arm/mach-sunxi/Kconfig | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm/mach-sunxi/Kconfig
b/arch/arm/mach-sunxi/Kconfig
index 09cfec6f57..1fededd0a3 100644
--- a/arch/arm/mach-sunxi/Kconfig
+++ b/arch/arm/mach-sunxi/Kconfig
@@ -397,9 +397,9 @@ config SYS_CLK_FREQ
default 1008000000 if MACH_SUN5I
default 1008000000 if MACH_SUN6I
default 912000000 if MACH_SUN7I
+ default 816000000 if MACH_SUN50I || MACH_SUN50I_H5
default 1008000000 if MACH_SUN8I
Even orangepi pc2 has 1.1v after power-on and it's work fine [1] did
you find an issue with neo2?
Yes, the boot process randomly hang at SPL stage -- but when it
enters
ATF it will run smoothly as the ATF will re-configure CPUx frequency
to 816MHz.
OK, Linux has similar issue, I will check it meanwhile.
According to the official operating point table [2], 1008MHz is bound
to 1.2V, and 816MHz is bound to 1.1V.
Does this common for all H5 SDK or orangepi design?
For all H5 SDK. It's the original comment in H5 SDK from AW.
thanks!
--
You received this message because you are subscribed to the Google Groups
"linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to linux-sunxi+unsubscr...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
