Guy Geens wrote:
>
> OK, I found a development version of ftape that would compile under
> Linux 2.2.
>
> (As a reminder: I installed a Ditto Max + EZ PnP controller.)
>
> After some tweaking, I got ftape to recognize the controller (see
> attached logs), but it still fails to recognize the drive itself.
>
> Mar 8 22:01:28 duff kernel: [010] 0 fdc-io.c (fdc_reset) - no drive polling
>interrupt!.
The last line isn't very nice.
> Mar 8 22:01:28 duff kernel: [011] 0 fdc-io.c (fdc_probe) - Iomega DASH EZ FDC
>found.
That seems pretty good.
> Mar 8 22:01:29 duff kernel: [012] 0 fdc-io.c (fdc_reset) - no drive polling
>interrupt!.
Again sh... Are you shure that your dirve is installed correctly? The
red line just _away_ from power? And your MCONFIG shows the same
parameters while found during /sbin/pnpdump > /etc/isapnp.conf and
enabled?
What says isapnp /etc/isapnp.conf? It must say something like this:
Board 1 has Identity 0f ff ff ff ff 40 00 ed 25: IOM0040 Serial No
4294967295 [checksum 0f]
Board 2 has Identity ....
And a hint: disable the lines with trakker and bpck_dev (in MCONFIG
and ./modules/insert). This will produce less lines in your logfile.
#TRAKKER_DEV=0
#BPCK_DEV=0
Regards
Carsten
--
"Etwas nicht tun zu k�nnen, ist kein Grund, es nicht zu tun."
Gordon "Alf" Shummway
Registered Linux User: 106265
