Mahlzeit
I have a new USB smart card reader, which is a prototype.
I got with linux 2.2.16 (RH7.0):
usb.c: USB new device connect, assigned device number 2
usb-uhci-debug.h: TD @ cf3f1f60/0F3F1F60, MaxLen=07 DT0 EP=0 Dev=0 PID=(SETUP)
buf=0f5ab100
usb-uhci-debug.h: Len=07 e0 Stalled CRC/Timeo
usb-uhci-debug.h: Link points to TD @ 0f3f1fa0, Breadth first
usb.c: USB device not accepting new address (error=-110)
And with 2.4.2-ac28:
hub.c: USB new device connect on bus1/1, assigned device number 2
usb-uhci.c: interrupt, status 2, frame# 102
usb.c: USB device not accepting new address=2 (error=-110)
I´ve seen a similar problem in the ML archive, but found no response
to it.
A webcam is listet correctly. So what is the problem? Is it the
reader or the linux USB driver (usb-uhci or usbcore)?
Mahlzeit
endergone Zwiebeltuete
------------------------------------------------------------------
Bus 0, device 0, function 0:
Host bridge: VIA Technologies, Inc. VT8363/8365 [KT133/KM133] (rev 3).
Prefetchable 32 bit memory at 0xd0000000 [0xd3ffffff].
Bus 0, device 1, function 0:
PCI bridge: VIA Technologies, Inc. VT8363/8365 [KT133/KM133 AGP] (rev 0).
Master Capable. No bursts. Min Gnt=12.
Bus 0, device 7, function 0:
ISA bridge: VIA Technologies, Inc. VT82C686 [Apollo Super South] (rev 64).
Bus 0, device 7, function 1:
IDE interface: VIA Technologies, Inc. Bus Master IDE (rev 6).
Master Capable. Latency=32.
I/O at 0xa000 [0xa00f].
Bus 0, device 7, function 2:
USB Controller: VIA Technologies, Inc. UHCI USB (rev 22).
IRQ 10.
Master Capable. Latency=32.
I/O at 0xa400 [0xa41f].
Bus 0, device 7, function 3:
USB Controller: VIA Technologies, Inc. UHCI USB (#2) (rev 22).
IRQ 10.
Master Capable. Latency=32.
I/O at 0xa800 [0xa81f].
------------------------------------------------------------------
_______________________________________________
[EMAIL PROTECTED]
To unsubscribe, use the last form field at:
http://lists.sourceforge.net/lists/listinfo/linux-usb-devel
