Mahlzeit
On Mon, Apr 16, 2001 at 04:21:24PM +0200, johan verrept wrote:
> Matthias Bruestle wrote:
> > And with 2.4.2-ac28:
> >
> > hub.c: USB new device connect on bus1/1, assigned device number 2
> > usb-uhci.c: interrupt, status 2, frame# 102
> > usb.c: USB device not accepting new address=2 (error=-110)
> The debug output from usb-uhci suggests the reader. the control request to assign a
>usb address to
> it times out or the endpoint is stalled.
Is it possible to extend this timeout? Or are there other tests I can do
to verify that it is the readers fault?
I have seen it once operating. I think it was with 2.2.16. The
output of usb-view was then
Unknown Device
Speed: 12Mb/s (full)
USB Version: 1.00
Device Class: 00(>ifc )
Device Subclass: 00
Device Protocol: 00
Maximum Default Endpoint Size: 16
Number of Configurations: 1
Vendor Id: 0c4b
Product Id: 0100
Revision Number: 1.00
Config Number: 1
Number of Interfaces: 1
Attributes: 80
MaxPower Needed: 300mA
Interface Number: 0
Name: (none)
Alternate Number: 0
Class: ff(vend.)
Sub Class: 0
Protocol: 0
Number of Endpoints: 3
Endpoint Address: 81
Direction: in
Attribute: 3
Type: Int.
Max Packet Size: 16
Interval: 16ms
Endpoint Address: 82
Direction: in
Attribute: 2
Type: Bulk
Max Packet Size: 64
Interval: 1ms
Endpoint Address: 02
Direction: out
Attribute: 2
Type: Bulk
Max Packet Size: 64
Interval: 1ms
I don't think there is something strange.
Mahlzeit
endergone Zwiebeltuete
_______________________________________________
[EMAIL PROTECTED]
To unsubscribe, use the last form field at:
http://lists.sourceforge.net/lists/listinfo/linux-usb-devel
