On Sun, 2004-06-06 at 11:01, Alan Stern wrote: > On 5 Jun 2004, Stephen Evanchik wrote: > > > Hello, > > > > Since Linux 2.6.6 I've not been able to use any USB devices. I see this > > error in the dmesg: > > > > usb 2-2: new full speed USB device using address 2 > > usb 2-2: device descriptor read/all, error 0 > > > > When I disconnect the device, the kernel oopses (see below). I tried > > 2.6.7-rc2 and had the same problem without the oops. > > > > Sorry if I am repeated / rehashing a known problem. I looked through the > > sf.net lists and read through a number of posts but couldn't find > > anything similar. > > Could you please make sure that USB debugging is turned on in your kernel > configuration, and then post a more complete dmesg output? From the > one-line error message shown here it's hard to tell exactly what the > problem is.
Sure, Linux 2.6.7-rc2 Plug in device: uhci_hcd 0000:00:1d.1: wakeup_hc uhci_hcd 0000:00:1d.1: port 2 portsc 0082 hub 2-0:1.0: port 2, status 0100, change 0001, 12 Mb/s uhci_hcd 0000:00:1d.1: port 2 portsc 0093 hub 2-0:1.0: port 2, status 0101, change 0001, 12 Mb/s hub 2-0:1.0: debounce: port 2: delay 100ms stable 4 status 0x101 usb 2-2: new full speed USB device using address 2 usb 2-2: device descriptor read/all, error 0 usb 2-2: new full speed USB device using address 3 usb 2-2: device descriptor read/all, error 0 Remove Device: uhci_hcd 0000:00:1d.1: port 2 portsc 0082 hub 2-0:1.0: port 2, status 0100, change 0001, 12 Mb/s uhci_hcd 0000:00:1d.1: suspend_hc Stephen ------------------------------------------------------- This SF.Net email is sponsored by the new InstallShield X. >From Windows to Linux, servers to mobile, InstallShield X is the one installation-authoring solution that does it all. Learn more and evaluate today! http://www.installshield.com/Dev2Dev/0504 _______________________________________________ [EMAIL PROTECTED] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-devel
