On Fri, 10 Nov 2006 [EMAIL PROTECTED] wrote:
> Hello Again Alan and Oliver
>
>
>
> Files attached per above. Verified three CONFIG's were marked y in
> .config. Used 2.6.15.7 and 2.6.18.2 vanilla, started from scratch except
> for downloading. Verified the scanner was still working in 15.7 but not
> in 18.2. Also did a modprobe usbmon to make sure it was loaded althought
> it should have been in the kernels. Used cat /sys/kernel/debug/usbmon/1t
> > x_mon.out for each. The HAL daemon failed on 2.6.18 boot up as before.
> Hopefully waited long enough to capture relevant data before killing cat
> process.
>
> Everything seemed to go okay but files are a little shorter than
> expected. Let me know if I need to run anything again.
You didn't do what I asked in regard to the dmesg log. To repeat the
instructions, this time with a small addition:
Before turning on the scanner, run "dmesg -c >/dev/null".
Also start the "cat" process for usbmon.
Turn on the scanner, and then a minute or so later do
"lsusb -v".
After lsusb finishes, run dmesg and post a copy of its output,
along with the output from usbmon.
The dmesg files you included didn't contain anything of interest. But the
usbmon output did include a hint of a problem. It's hard to tell at this
point, I'll need to see the additional results from running lsusb.
Alan Stern
-------------------------------------------------------------------------
Using Tomcat but need to do more? Need to support web services, security?
Get stuff done quickly with pre-integrated technology to make your job easier
Download IBM WebSphere Application Server v.1.0.1 based on Apache Geronimo
http://sel.as-us.falkag.net/sel?cmd=lnk&kid=120709&bid=263057&dat=121642
_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel
