On Wed, 7 Mar 2001, Massimo Pinto wrote:
> **** Rafael R. Sevilla wrote:
>
> RRS >Why are you trying to load the OHCI module? Does your system have an OHCI
> RRS >USB controller? To the best of my knowledge, most commodity PC's only
> RRS >have UHCI controllers, OHCI's being common only on Macs and a few notebook
> RRS >pc's. Obviously trying to load this module when you have the other kind
> RRS >of USB bridge will kill you.
>
I've made a slight mistake here. UHCI controllers are available on most
motherboards with Intel chipsets, while OHCI can be found on most
non-Intel systems such as Macs and other board makers such as SiS, ALI,
et. al.
> Hi Rafael. When I upgraded my Red Hat distribution to Red Hat 7.0, which
> included a kernel 2.2.16-22, at my next re-boot I was asked whether I
> wanted to configure the new hardware found: namely the USB controller. I
> said yes, and I found out later that the ohci module had been loaded. I am
> not sure now whether this is indicating that my controller is a ohci type,
> although the dmesg output that I include below indicates this.
>
Use lspci to show all the devices Linux detects on your system. If you
see a USB Controller made by Intel, you have a UHCI controller. If you
see a controller made by anyone else, most likely it's OHCI.
--
Rafael R. Sevilla <[EMAIL PROTECTED]> +63 (2) 4342217
UP Diliman Mobile Robotics Laboratory +63 (917) 4458925
OpenPGP Key ID: 0x0E8CE481
_______________________________________________
[EMAIL PROTECTED]
To unsubscribe, use the last form field at:
http://lists.sourceforge.net/lists/listinfo/linux-usb-users
