Hi;
I'm running RH 2.2.18 kernel on a P100 Acer with a PCI USB card.
The output of /proc/pci (lspci -vv) is as follows;
<---------------------------------------------------
snip-----------------------------------------------------------------------
------->
00:0f.0 USB Controller: CMD Technology Inc USB0670 (rev 06) (prog-if 10
[OHCI])
Subsystem: CMD Technology Inc: Unknown device 0670
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Step
ping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort
- <MAbort- >SERR- <PERR-
Latency: 2 min, 4 max, 96 set
Interrupt: pin A routed to IRQ 0
Region 0: Memory at 04000000 (32-bit, non-prefetchable)
Capabilities: <available only to root>
<--------------------------------------------------------------------------
---------------------------------------------------------------->
I can load the usbcore module successfully however I get the following
output in the /var/log/messages file when doing a insmod usb-ohci;
<---------------------------------------------------
snip-----------------------------------------------------------------------
------->
Apr 4 20:50:28 pps kernel: usb-ohci.c: USB OHCI at membase 0xc383f000, IRQ
0
Apr 4 20:50:28 pps kernel: usb.c: new USB bus registered, assigned bus
number 1
Apr 4 20:50:28 pps kernel: usb-ohci.c: request interrupt 0 failed
Apr 4 20:50:28 pps kernel: usb.c: USB bus 1 deregistered
<--------------------------------------------------------------------------
---------------------------------------------------------------->
Is there a way I can change the IRQ or is there a patch for this problem.
I'm at sea on this one.
Any help greatly appreciated. Thanks in advance.
rgds
Phil
_______________________________________________
[EMAIL PROTECTED]
To unsubscribe, use the last form field at:
http://lists.sourceforge.net/lists/listinfo/linux-usb-users
