-----BEGIN PGP SIGNED MESSAGE-----
I've investigated some more, and discovered that the scsi-generic
deivce /dev/sg2 appears to be my CF card reader (as described below). But,
it's a character device, not a block device, so I can't mount it. I did
scsi_info on every device starting with "s" in /dev, and that was the only
one that was associated with the card reader. If anyone has any
suggestions for getting ide-scsi and usb-storage working at the same time,
I would love to hear them. My prior message (which had a poor title) is
included below. I saw that in the archives there were other people having
trouble with usb-storage and other scsi devices, but none of them seemed
to have the devices listed in the /proc/scsi and proc/bus/usb areas. They
also didn't seem to have any clean solutions... Is there some way, given
the correct SCSI HBA, bus, id, and lun, to use mknod to create a device
that would correspond to it? I've tried using "scsidev", and it creates a
block device corresponding the the USB CF card reader, but it behaves just
like /dev/sda1: scsi_info says "open() failed: no such device", and mount
says "mount: sdh1-0c0i0l0: unknown device" :| So, I think something is
wrong.
> Earlier today, I had a USB mass storage device working (my CF card
> reader). I mounted /dev/sda1 and voila, there were all of my photos.
> This afternoon, I installed a CD-RW drive, and set up ide-scsi
> emulation, so I can use cdrecord, cdrdao, etc. Apparently as a
> consequence of that, my flash card reader is no longer availible at
> /dev/sda1, nor at sdb1, sdc1, etc etc. All of these devices give me
> "XXXX, unknown device" when I try to mount them.
> /proc/scsi/scsi contains the following:
>
> Attached devices:
> Host: scsi0 Channel: 00 Id: 00 Lun: 00
> Vendor: MITSUMI Model: CD-ROM FX320M !B Rev: m01
> Type: CD-ROM ANSI SCSI revision: 02
> Host: scsi0 Channel: 00 Id: 01 Lun: 00
> Vendor: SAF Model: CD-RW4224A Rev: 1.20
> Type: CD-ROM ANSI SCSI revision: 02
> Host: scsi1 Channel: 00 Id: 00 Lun: 00
> Vendor: SanDisk Model: ImageMate II Rev: 1.30
> Type: Direct-Access ANSI SCSI revision: 02
>
> scsi_info doesn't give me any interesting information about the devices,
> just "open() failed: No such device or address".
> The card reader still shows up in /proc/bus/usb/devices just fine:
>
> T: Bus=01 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 2 Spd=12 MxCh= 0
> D: Ver= 1.10 Cls=00(>ifc ) Sub=00 Prot=00 MxPS=64 #Cfgs= 1
> P: Vendor=0781 ProdID=0002 Rev= 0.09
> S: Manufacturer=SanDisk Corporation
> S: Product=ImageMate CompactFlash USB
> S: SerialNumber=000000000002
> C:* #Ifs= 1 Cfg#= 1 Atr=40 MxPwr=100mA
> I: If#= 0 Alt= 0 #EPs= 2 Cls=08(stor.) Sub=06 Prot=50 Driver=usb-storage
> E: Ad=82(I) Atr=02(Bulk) MxPS= 64 Ivl= 0ms
> E: Ad=02(O) Atr=02(Bulk) MxPS= 64 Ivl= 0ms
>
> But I have no idea how to figure out how to access it. Are there tools
> for figuring this kind of thing out? Does anyone know just from looking
> at the information above what the device would be? Am I even looking at
> the right problem?
>
> -- Zane
>
> ===========================================================================
> Zane A. Crawford __o [EMAIL PROTECTED]
> home : 626.585.1712 _`\<,_ http://zane.ideotrope.org
> work : 626.395.6981 (*)/ (*) "We are all ideologues; some of us
> BS, E&AS, Caltech 1998 just choose our ideas with more
> finger me for my PGP key care than others."
> ===========================================================================
>
- -- Zane
===========================================================================
Zane A. Crawford __o [EMAIL PROTECTED]
home : 626.585.1712 _`\<,_ http://zane.ideotrope.org
work : 626.395.6981 (*)/ (*) "We are all ideologues; some of us
BS, E&AS, Caltech 1998 just choose our ideas with more
finger me for my PGP key care than others."
===========================================================================
-----BEGIN PGP SIGNATURE-----
Version: 2.6.2
iQCVAwUBOvb7PGNph2tAwDMNAQH+6wP/aUiuG52Bx9qtJl+pGA2qC0icTbkLr+p1
OAlE3DyksYiwNAL6QlzHuw6E0coYrRLGM6NTjx7yMCf+/gdkzvzaBNzYfFMVNyGg
3r1gIrNP5gA/9slZXqQp6MQmOnNNKjrn8a85SVUSezDk3tmbX9EoZw1m9hxn276N
FwwXXGEmrp8=
=q82c
-----END PGP SIGNATURE-----
_______________________________________________
[EMAIL PROTECTED]
To unsubscribe, use the last form field at:
http://lists.sourceforge.net/lists/listinfo/linux-usb-users
