more details:
here are the message I get at the beginning (look good)
usb.c: registered new driver ov511
ov511.c: USB OV511+ camera found
ov511.c: camera: Creative Labs WebCam 3
ov511.c: Sensor is an OV7620
ov511.c: ov511 driver version 1.40 registered
and here is what I get when I try and run xawtv's webcam:
[root@localhost bastien]# webcam webcam.conf
reading config file: webcam.conf
v4l: open /dev/video0: Cannot allocate memory
no grabber device available
dmesg:
uhci: host controller process error. something bad happened
uhci: host controller halted. very bad
usb_control/bulk_msg: timeout
ov511.c: reg write: error -110
at the same moment, the little green light on the camera turns off.
other point: I managed to succesfully mount /proc/bus/usb/ , thanks for
helping !
--Bastien
Brad Hards wrote:
> Bastien Raich wrote:
> >
> > hmmm...
> >
> > it seems like it does not want to work.
> > I recompiled the kernel again, doublechecked I had the Preliminary USB
> > device filesystem enabled. but I still can't see /proc/bus/usb/devices.
> Does /proc/bus/usb exist? Did you mount it?
>
> > I also updated to the ov511-1.40 version.
> >
> > as for usb, I get the correct messages, but:
> >
> > - I try and run webcam, get this error:
> > v4l2: open /dev/video0: can't allocate memory
> > v4l: open /dev/video0: can't allocate memory
> Have you tried camstream?
>
> Brad
>
> _______________________________________________
> [EMAIL PROTECTED]
> To unsubscribe, use the last form field at:
> http://lists.sourceforge.net/lists/listinfo/linux-usb-users
_______________________________________________
[EMAIL PROTECTED]
To unsubscribe, use the last form field at:
http://lists.sourceforge.net/lists/listinfo/linux-usb-users
