John Schrader wrote:

>I tried to get a ScanLogic USB/IDE case to work under Linux (SuSE 8.0,
>kernel 2.4.18), but without luck until now.
>
>After connecting it, /proc/bus/usb/devices contains this information
>for the device:
>
>  T:  Bus=01 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#=  3 Spd=12  MxCh= 0
>  D:  Ver= 1.10 Cls=00(>ifc ) Sub=00 Prot=00 MxPS= 8 #Cfgs=  1
>  P:  Vendor=04ce ProdID=0002 Rev= 2.60
>  S:  Manufacturer=ScanLogic USBIDE
>  
>
.......

>  19:37:28 pharaoh kernel: scsi0 : SCSI emulation for USB Mass Storage
>           devices
>  19:37:46 pharaoh kernel: usb.c: USB disconnect on device 3
>  19:37:47 pharaoh kernel: hub.c: USB new device connect on bus1/1,
>           assigned device number 4
>  19:37:48 pharaoh modprobe: modprobe: Can't locate module block-major-11
>  19:37:49 pharaoh last message repeated 15 times
>  19:37:49 pharaoh kernel: resize_dma_pool: unknown device type -1
>  19:37:51 pharaoh kernel: usb-uhci.c: interrupt, status 3, frame# 292
>  19:37:51 pharaoh kernel: scsi: device set offline - not ready or
>           command retry failed after bus reset:
>           host 0 channel 0 id 0 lun 0
>  
>

Hello, I have an ISD USB 2.0 box, the same distri,, and my experience 
was similar to what you file here, because the disk was not yet up, most 
of the times, I think. It helped, first to switch the box on, wait, and 
only then plug the usb cable. I did some bonnie testing and got never 
any failure. Further, unplugging and replugging never worked for me, 
which I don't mind.

In the meantime, I installed besides my VIA UHCI a NEC USB 2.0 host 
card, and use a 2.5.24 kernel, and this works also perfectly. Maybe it 
helps you while solving your problem: After I boot my otherwise 
unchanged SuSE 8.0 system in 2.5.24, I rmmod usb-uhci, insmod 
usb-uhci-hcd (or usb-hcd) for the USB mouse, and then insmod ehci-hcd. 
For the mouse and the IDE drive hotplug does it's magic successfully. I 
only did the changes according to SuSE's sdb. By this you may have 
access to the most recent USB drivers.

Regards,
Georg.



-------------------------------------------------------
Sponsored by:
ThinkGeek at http://www.ThinkGeek.com/
_______________________________________________
[EMAIL PROTECTED]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-users

Reply via email to