The USB 2.0 specification uses the term "High Speed" to
refer to 480Mb/s and "Full Speed" to refer to 12Mb/sec (the fastest
speed available in USB 1.0 and 1.1). I believe that the status messages
are referring to USB 1.x speeds, and therefore should use the term
"Full Speed" rather than "High Speed". The following trivial patch
makes that change.
Adam J. Richter __ ______________ 4880 Stevens Creek Blvd, Suite 104
[EMAIL PROTECTED] \ / San Jose, California 95129-1034
+1 408 261-6630 | g g d r a s i l United States of America
fax +1 408 261-6631 "Free Software For The Rest Of Us."
-------------------------CUT HERE--------------------------------------
--- linux-2.3.99-pre9-2/drivers/usb/hub.c Mon May 15 22:18:49 2000
+++ linux/drivers/usb/hub.c Mon May 15 22:17:35 2000
@@ -338,7 +338,7 @@
portstatus = le16_to_cpu(portsts.wPortStatus);
portchange = le16_to_cpu(portsts.wPortChange);
dbg("portstatus %x, change %x, %s", portstatus, portchange,
- portstatus&(1<<USB_PORT_FEAT_LOWSPEED) ? "Low Speed" : "High Speed");
+ portstatus&(1<<USB_PORT_FEAT_LOWSPEED) ? "Low Speed" : "Full Speed");
/* Clear the connection change status */
usb_clear_port_feature(hub, port + 1, USB_PORT_FEAT_C_CONNECTION);
@@ -369,7 +369,7 @@
portstatus = le16_to_cpu(portsts.wPortStatus);
portchange = le16_to_cpu(portsts.wPortChange);
dbg("portstatus %x, change %x, %s", portstatus ,portchange,
- portstatus&(1<<USB_PORT_FEAT_LOWSPEED) ? "Low Speed" : "High
Speed");
+ portstatus&(1<<USB_PORT_FEAT_LOWSPEED) ? "Low Speed" : "Full
+Speed");
if ((portchange & USB_PORT_STAT_C_CONNECTION) ||
!(portstatus & USB_PORT_STAT_CONNECTION))
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
