> > > > ++++++++++++++++++++++++++++++
> > > > 1 file changed, 30 insertions(+)
> > > >
> > > > diff --git a/arch/arm/boot/dts/imx7ulp.dtsi
> > > > b/arch/arm/boot/dts/imx7ulp.dtsi index fca6e50f37c8..e2944f98eac6
> > > > 100644
> > > > --- a/arch/arm/boot/dts/imx7ulp.dtsi
> > > > +++ b/arch/arm/boot/dts/imx7ulp.dtsi
> > > > @@ -30,6 +30,7 @@
> > > > serial1 = &lpuart5;
> > > > serial2 = &lpuart6;
> > > > serial3 = &lpuart7;
> > > > + usbphy0 = &usbphy1;
> > >
> > > Drop this. You shouldn't need an alias.
> > >
> >
> > It is a derived USB PHY and used on most of i.mx chipidea USB controllers.
> > At the source code, we use aligned id to know the controller number.
> >
> > ret = of_alias_get_id(np, "usbphy");
> > if (ret < 0)
> > dev_dbg(&pdev->dev, "failed to get alias id, errno %d\n",
> > ret);
> > mxs_phy->port_id = ret;
>
> fsl,anatop property should probably have cell to specify this.
>
imx7ulp doesn't have anatop part, the analog for imx7ulp is different with imx6.
> >
> > > > };
> > > >
> > > > cpus {
> > > > @@ -133,6 +134,35 @@
> > > > clock-names = "ipg", "per";
> > > > };
> > > >
> > > > + usbotg1: usb@40330000 {
> > > > + compatible = "fsl,imx7ulp-usb",
> > > > "fsl,imx6ul-usb",
> > > > + "fsl,imx27-usb";
> > > > + reg = <0x40330000 0x200>;
> > > > + interrupts = <GIC_SPI 40 IRQ_TYPE_LEVEL_HIGH>;
> > > > + clocks = <&pcc2 IMX7ULP_CLK_USB0>;
> > > > + fsl,usbphy = <&usbphy1>;
> > >
> > > Don't use this for new users. Use the phy binding instead.
> > >
> >
> > It is not a new user, the USB PHY used at imx7ulp is the same with imx6's.
>
> New SoC is a new user. The chipidea core already supports using 'phys'
> so you should be able to just use the common code.
>
Thanks, will use below, and change the imx glue layer code which "fsl,usbphy"
phandle is mandatory now.
phys = <&usbphy1>; /* for usbotg1 */
and
#phy-cells = <0>; /* for usbphy1 */
Peter
