On 12/21/2016 05:50 PM, Hans de Goede wrote:
Hi,
On 21-12-16 13:07, George Cherian wrote:
On 12/21/2016 05:12 PM, Oliver Neukum wrote:
On Wed, 2016-12-21 at 17:09 +0530, George Cherian wrote:
Hi Oliver,
I was working with this JMicron device and using the uas driver.
I am seeing the following 2 issues.
1) On connect I see the following messages.
Thanks. Do you want to submit it to Greg?
The patch is fine.
Yes please!!!
2) On disconnect I am seeing the following issue
scsi host4: uas_post_reset: alloc streams error -19 after reset
sd 4:0:0:0: [sdb] Synchronizing SCSI cache
This is more fatal because after these messages the USB port becomes
unusable. Even an lsusb invocation hangs for ever.
Ouch. That points to a logic error. We should not reset if
a device is gone.
Could you send dmesg of such a case?
here is the dmesg!!
[ 203.475382] usb 4-1.3: new SuperSpeed USB device number 3 using
xhci_hcd
[ 203.496172] usb 4-1.3: New USB device found, idVendor=152d,
idProduct=9561
[ 203.503037] usb 4-1.3: New USB device strings: Mfr=1, Product=2,
SerialNumber=5
[ 203.510352] usb 4-1.3: Product: JMS56x Series
[ 203.514698] usb 4-1.3: Manufacturer: JMicron
[ 203.518966] usb 4-1.3: SerialNumber: 00000000000000000000
[ 203.594383] usbcore: registered new interface driver usb-storage
[ 203.612425] scsi host4: uas
[ 203.615418] usbcore: registered new interface driver uas
[ 203.620979] scsi 4:0:0:0: Direct-Access ST4000NM 0033-9ZM170
0001 PQ: 0 ANSI: 6
[ 203.630240] sd 4:0:0:0: Attached scsi generic sg1 type 0
[ 203.630382] sd 4:0:0:0: [sdb] 7814037168 512-byte logical blocks:
(4.00 TB/3.63 TiB)
[ 203.631338] sd 4:0:0:0: [sdb] Write Protect is off
[ 203.631342] sd 4:0:0:0: [sdb] Mode Sense: 67 00 10 08
[ 203.631734] sd 4:0:0:0: [sdb] Write cache: enabled, read cache:
enabled, supports DPO and FUA
[ 203.631899] xhci_hcd 0000:00:11.0: ERROR Transfer event for
disabled endpoint or incorrect stream ring
[ 203.631904] xhci_hcd 0000:00:11.0: @0000001f610a1c10 00000000
00000000 1b000000 03078001 state 14 ep_info 9403
[ 203.631906] xhci_hcd 0000:00:11.0: No epring
[ 203.674546] sdb: sdb1
[ 203.676639] sd 4:0:0:0: [sdb] Attached SCSI disk
[ 213.222913] scsi host4: uas_post_reset: alloc streams error -19
after reset
[ 213.230548] sd 4:0:0:0: [sdb] Synchronizing SCSI cache
Above is the dmesg without the unusual_uas patch applied.
Do you need me to enable any specific dev_dbg and then the dmesg output?
Can you get us a dmesg with the unusual_uas patch applied? Usually once
things go foobar because
of issue-ing a command which the device does not understand, more things
typically come down
as both the device and the host may be in an undefined state then.
Here is the lsusb -t
============================================================================
lsusb -t
/: Bus 04.Port 1: Dev 1, Class=root_hub, Driver=xhci_hcd/1p, 5000M
|__ Port 1: Dev 2, If 0, Class=Hub, Driver=hub/4p, 5000M
|__ Port 3: Dev 4, If 0, Class=Mass Storage, Driver=uas, 5000M
/: Bus 03.Port 1: Dev 1, Class=root_hub, Driver=xhci_hcd/1p, 480M
|__ Port 1: Dev 2, If 0, Class=Hub, Driver=hub/4p, 480M
/: Bus 02.Port 1: Dev 1, Class=root_hub, Driver=xhci_hcd/1p, 5000M
/: Bus 01.Port 1: Dev 1, Class=root_hub, Driver=xhci_hcd/1p, 480M
lsusb
Bus 003 Device 002: ID 0bda:5401 Realtek Semiconductor Corp. RTL 8153
USB 3.0 hub with gigabit ethernet
Bus 004 Device 002: ID 0bda:0401 Realtek Semiconductor Corp.
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 002 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
Bus 003 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 004 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
Bus 004 Device 004: ID 152d:9561 JMicron Technology Corp. / JMicron USA
Technology Corp.
lsusb -v
Bus 004 Device 004: ID 152d:9561 JMicron Technology Corp. / JMicron USA
Technology Corp.
Device Descriptor:
bLength 18
bDescriptorType 1
bcdUSB 3.00
bDeviceClass 0 (Defined at Interface level)
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 9
idVendor 0x152d JMicron Technology Corp. / JMicron USA
Technology Corp.
idProduct 0x9561
bcdDevice 0.01
iManufacturer 1 JMicron
iProduct 2 JMS56x Series
iSerial 5 00000000000000000000
bNumConfigurations 1
Configuration Descriptor:
bLength 9
bDescriptorType 2
wTotalLength 121
bNumInterfaces 1
bConfigurationValue 1
iConfiguration 4 USB Mass Storage
bmAttributes 0xc0
Self Powered
MaxPower 2mA
Interface Descriptor:
bLength 9
bDescriptorType 4
bInterfaceNumber 0
bAlternateSetting 0
bNumEndpoints 2
bInterfaceClass 8 Mass Storage
bInterfaceSubClass 6 SCSI
bInterfaceProtocol 80 Bulk-Only
iInterface 6 MSC Bulk-Only Transfer
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x81 EP 1 IN
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0400 1x 1024 bytes
bInterval 0
bMaxBurst 15
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x02 EP 2 OUT
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0400 1x 1024 bytes
bInterval 0
bMaxBurst 15
Interface Descriptor:
bLength 9
bDescriptorType 4
bInterfaceNumber 0
bAlternateSetting 1
bNumEndpoints 4
bInterfaceClass 8 Mass Storage
bInterfaceSubClass 6 SCSI
bInterfaceProtocol 98
iInterface 10 MSC BOT/UAS Transfer
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x01 EP 1 OUT
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0400 1x 1024 bytes
bInterval 0
bMaxBurst 0
Command pipe (0x01)
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x82 EP 2 IN
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0400 1x 1024 bytes
bInterval 0
bMaxBurst 0
MaxStreams 32
Status pipe (0x02)
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x83 EP 3 IN
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0400 1x 1024 bytes
bInterval 0
bMaxBurst 15
MaxStreams 32
Data-in pipe (0x03)
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x04 EP 4 OUT
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0400 1x 1024 bytes
bInterval 0
bMaxBurst 15
MaxStreams 32
Data-out pipe (0x04)
Binary Object Store Descriptor:
bLength 5
bDescriptorType 15
wTotalLength 22
bNumDeviceCaps 2
USB 2.0 Extension Device Capability:
bLength 7
bDescriptorType 16
bDevCapabilityType 2
bmAttributes 0x00000002
Link Power Management (LPM) Supported
SuperSpeed USB Device Capability:
bLength 10
bDescriptorType 16
bDevCapabilityType 3
bmAttributes 0x00
wSpeedsSupported 0x000e
Device can operate at Full Speed (12Mbps)
Device can operate at High Speed (480Mbps)
Device can operate at SuperSpeed (5Gbps)
bFunctionalitySupport 1
Lowest fully-functional device speed is Full Speed (12Mbps)
bU1DevExitLat 10 micro seconds
bU2DevExitLat 32 micro seconds
Device Status: 0x0001
Self Powered
=======================================================================
Connect and disconnect dmesg without uas and usb_storage
[ 56.205374] usb 4-1.3: new SuperSpeed USB device number 3 using xhci_hcd
[ 56.226152] usb 4-1.3: New USB device found, idVendor=152d,
idProduct=9561
[ 56.233017] usb 4-1.3: New USB device strings: Mfr=1, Product=2,
SerialNumber=5
[ 56.240332] usb 4-1.3: Product: JMS56x Series
[ 56.244677] usb 4-1.3: Manufacturer: JMicron
[ 56.248945] usb 4-1.3: SerialNumber: 00000000000000000000
[ 337.530073] usb 4-1.3: USB disconnect, device number 3
=======================================================================
Here is the dmesg output with the unusual_uas patch applied
[ 832.995364] usb 4-1.3: new SuperSpeed USB device number 5 using xhci_hcd
[ 833.016186] usb 4-1.3: New USB device found, idVendor=152d,
idProduct=9561
[ 833.023051] usb 4-1.3: New USB device strings: Mfr=1, Product=2,
SerialNumber=5
[ 833.030365] usb 4-1.3: Product: JMS56x Series
[ 833.034710] usb 4-1.3: Manufacturer: JMicron
[ 833.038977] usb 4-1.3: SerialNumber: 00000000000000000000
[ 833.045767] scsi host5: uas
[ 833.049191] scsi 5:0:0:0: Direct-Access ST4000NM 0033-9ZM170
0001 PQ: 0 ANSI: 6
[ 833.058454] sd 5:0:0:0: Attached scsi generic sg1 type 0
[ 833.063792] sd 5:0:0:0: [sdb] 7814037168 512-byte logical blocks:
(4.00 TB/3.63 TiB)
[ 833.072483] sd 5:0:0:0: [sdb] Write Protect is off
[ 833.077277] sd 5:0:0:0: [sdb] Mode Sense: 67 00 10 08
[ 833.077678] sd 5:0:0:0: [sdb] Write cache: enabled, read cache:
enabled, supports DPO and FUA
[ 833.144571] sdb: sdb1
[ 833.149095] sd 5:0:0:0: [sdb] Attached SCSI disk
[ 843.149653] scsi host5: uas_post_reset: alloc streams error -19 after
reset
[ 843.157268] sd 5:0:0:0: [sdb] Synchronizing SCSI cache
========================================================================
Regards,
Hans
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
