On Fri, 23 Dec 2016, George Cherian wrote:
> >> 2) On disconnect I am seeing the following issue
> >>
> >> scsi host4: uas_post_reset: alloc streams error -19 after reset
> >> sd 4:0:0:0: [sdb] Synchronizing SCSI cache
> >>
> >> This is more fatal because after these messages the USB port becomes
> >> unusable. Even an lsusb invocation hangs for ever.
> > This problem looks pretty simple. uas doesn't check properly to see if
> > the device was disconnected following a reset.
> >
> > Try changing the line in uas_post_reset() that says:
> >
> > if (devinfo->shutdown)
> >
> > to:
> >
> > if (devinfo->shutdown ||
> > devinfo->udev->state == USB_STATE_NOTATTACHED)
> Yes this works for me but with a little bit change as follows, But am
> not sure whether we should goto reset_scsi in case of shutdown.
> Please advice.
>
> diff --git a/drivers/usb/storage/uas.c b/drivers/usb/storage/uas.c
> index 5ef014b..24db3fd 100644
> --- a/drivers/usb/storage/uas.c
> +++ b/drivers/usb/storage/uas.c
> @@ -1072,8 +1072,8 @@ static int uas_post_reset(struct usb_interface *intf)
> unsigned long flags;
> int err;
>
> - if (devinfo->shutdown)
> - return 0;
> + if (devinfo->shutdown || devinfo->udev->state ==
> USB_STATE_NOTATTACHED)
> + goto reset_scsi;
>
> err = uas_configure_endpoints(devinfo);
> if (err) {
> @@ -1083,6 +1083,7 @@ static int uas_post_reset(struct usb_interface *intf)
> return 1;
> }
>
> +reset_scsi:
> spin_lock_irqsave(shost->host_lock, flags);
> scsi_report_bus_reset(shost, 0);
> spin_unlock_irqrestore(shost->host_lock, flags);
As far as I can tell, adding the "goto reset_scsi" line does not help
at all. There's no reason to report that the bus has been reset after
the device is gone.
Alan Stern
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
