Hi Biju-san, IIUC, when we submitted a patch for dts[i] file, we don't need to submit such a patch to usb maintainers.
> From: Biju Das, Sent: Monday, October 16, 2017 7:13 PM > > From: Fabrizio Castro <[email protected]> > > Add node for xhci. Boards DT files will enable it if needed. > > Signed-off-by: Fabrizio Castro <[email protected]> > --- > arch/arm/boot/dts/r8a7743.dtsi | 20 ++++++++++++++++++++ > 1 file changed, 20 insertions(+) > > diff --git a/arch/arm/boot/dts/r8a7743.dtsi b/arch/arm/boot/dts/r8a7743.dtsi > index 699c040..386bf07 100644 > --- a/arch/arm/boot/dts/r8a7743.dtsi > +++ b/arch/arm/boot/dts/r8a7743.dtsi > @@ -931,6 +931,26 @@ > status = "disabled"; > }; > > + /* > + * pci1 and xhci share the same phy, therefore only one of them > + * can be active at any one time. If both of them are enabled, > + * a race condition will determine who'll control the phy. > + * A firmware file is needed by the xhci driver in order for > + * USB 3.0 to work properly. > + */ > + xhci: usb@ee000000 { > + compatible = "renesas,xhci-r8a7743", > + "renesas,rcar-gen2-xhci"; > + reg = <0 0xee000000 0 0xc00>; > + interrupts = <GIC_SPI 101 IRQ_TYPE_LEVEL_HIGH>; > + clocks = <&cpg CPG_MOD 328>; > + power-domains = <&sysc R8A7743_PD_ALWAYS_ON>; > + resets = <&cpg 328>; > + phys = <&usb2 1>; > + phy-names = "usb"; > + status = "disabled"; > + }; > + > sdhi0: sd@ee100000 { > compatible = "renesas,sdhi-r8a7743"; > reg = <0 0xee100000 0 0x328>; It seems good to me. So, Reviewed-by: Yoshihiro Shimoda <[email protected]> Best regards, Yoshihiro Shimoda > -- > 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
