I resent this email with adding Mathias, Alan and Greg as CC.
-----Original Message-----
From: Yoshihiro Shimoda, Sent: Thursday, January 18, 2018 6:03 PM
To: [email protected]
Subject: Questions about "usb usb8-port1: cannot disable (err = -32)"
Hi,
My environment (R-Car H3) outputs the following error when I disconnected
a usb 3.0 SSD device from the xhci host controller.
[ 267.755777] xhci-hcd ee000000.usb: Cannot set link state.
[ 267.761188] usb usb8-port1: cannot disable (err = -32)
[ 267.772166] usb 8-1: USB disconnect, device number 2
But, the environment can detect connection again.
I investigate this issue and found the following commit is related:
37be6676 usb: hub: Fix auto-remount of safely removed or ejected USB-3 devices
The xhci-hub.c has the following code:
if ((temp & PORT_PE) == 0 ||
(link_state > USB_SS_PORT_LS_U3)) {
xhci_warn(xhci, "Cannot set link state.\n");
goto error;
}
And, the code above will be called by hub_set_port_link_state(...,
USB_SS_PORT_LS_U3)
in hub_port_disable():
/*
* USB-3 does not have a similar link state as USB-2 that will avoid negotiating
* a connection with a plugged-in cable but will signal the host when the cable
* is unplugged. Disable remote wake and set link state to U3 for USB-3 devices
*/
static int hub_port_disable(struct usb_hub *hub, int port1, int set_state)
{
struct usb_port *port_dev = hub->ports[port1 - 1];
struct usb_device *hdev = hub->hdev;
int ret = 0;
if (!hub->error) {
if (hub_is_superspeed(hub->hdev)) {
hub_usb3_port_prepare_disable(hub, port_dev);
ret = hub_set_port_link_state(hub, port_dev->portnum,
USB_SS_PORT_LS_U3);
The hub_port_disable() will be called by port_event():
/*
* Warm reset a USB3 protocol port if it's in
* SS.Inactive state.
*/
if (hub_port_warm_reset_required(hub, port1, portstatus)) {
dev_dbg(&port_dev->dev, "do warm reset\n");
if (!udev || !(portstatus & USB_PORT_STAT_CONNECTION)
|| udev->state == USB_STATE_NOTATTACHED) {
if (hub_port_reset(hub, port1, NULL,
HUB_BH_RESET_TIME, true) < 0)
hub_port_disable(hub, port1, 1);
However, according to Figure 35 in xhci spec, the PED will be set to 0
after the usb3 root hub enters "Error" or "Disconnected" state.
So, IIUC, a usb driver should not call hub_set_port_link_state() in such a case.
Question 1:
- Is my understanding correct?
Question 2:
- How do I resolve the issue? (I don't have any idea for now...)
Best regards,
Yoshihiro Shimoda
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
