On Thu, 2004-10-28 at 22:30, Rob Fraser wrote: > Hi All > > Just upgraded ipcop from 1.3 to 1.4.0 (by inserting the 1.3 backup disk > when prompted in the 1.4.0) > > I have a RED/GREEN configuration. My RED nic stays "unset" even when I > set it in setup. The result is that the RED interface is not brought up > on startup or after running setup. ifconfig shows only eth0 (GREEN) and > lo. Have swapped the nics around with an extra spare I had, but all > work OK with manual intervention as below. Hardware is nothing > special, P133 with 80Mb RAM and two 3COM 3C590s. > > If I manually run /etc/rc.d/rc.red from the command line, everything > bursts into life and runs like it used to before the upgrade (except it > now has the spiffy new web GUI and I haven't got dansguard running again > yet). eth1 (RED) comes up with correct settings. > > Couldn't find anything relevent on google, does anyone have any > suggestions on getting the RED to stay "set" and come up at startup? > > Thanks > Robert >
Possibly something to do with the two identical nic's which can be a pain. take a look in /var/ipcop/ethernet/settings and see if you can spot anything.
