Hi, Does the build process finishes without any warnings or errors? Best regards, Paulo
2009/12/7 Chris Wilkinson <blobster...@yahoo.com.au>: > Hi there, > > I've done as suggested below, but when I go to modprobe uvcvideo I get the > following... > > # modprobe uvcvideo > FATAL: Error inserting uvcvideo > (/lib/modules/2.6.25.18-0.2-default/weak-updates/uvcvideo.ko): Unknown > symbol in module, or unknown parameter (see dmesg) > > dmesg shows the same as before. > > I'm not sure what 'unknown symbol' means, but are there any parameters I can > pass to uvcvideo when I try to load it? > > Kind regards > > Chris Wilkinson, Brisbane, Australia. > > ________________________________ > From: Paulo Assis <pj.as...@gmail.com> > To: Chris Wilkinson <blobster...@yahoo.com.au>; linux-uvc development > discussions <linux-uvc-devel@lists.berlios.de> > Sent: Mon, 7 December, 2009 7:21:14 PM > Subject: Re: [Linux-uvc-devel] New UVC webcam not working > > Hi, > You haven't unloaded the old modules. > If you got the source from the mercurial repo you should follow this steps: > > 1- make distclean > 2- make menuconfig (optional - must be run as root) > 3- make > 4- make install > 5- make unload > 6- modprobe uvcvideo (as root) > > Best regards, > Paulo > > ________________________________ > See what's on at the movies in your area. Find out now. _______________________________________________ Linux-uvc-devel mailing list Linux-uvc-devel@lists.berlios.de https://lists.berlios.de/mailman/listinfo/linux-uvc-devel
