Hi

On 2018-04-06, Kalle Valo wrote:
> From: Sebastian Gottschall <s.gottsch...@newmedia-net.de>
> 
> Adds LED and GPIO Control support for 988x, 9887, 9888, 99x0, 9984 based
> chipsets with on chipset connected led's using WMI Firmware API.  The LED
> device will get available named as "ath10k-phyX" at sysfs and can be 
> controlled
> with various triggers.  adds also debugfs interface for gpio control.
> 
> Signed-off-by: Sebastian Gottschall <s.gottsch...@dd-wrt.com>
> Reviewed-by: Steve deRosier <deros...@cal-sierra.com>
> [kvalo: major reorg and cleanup]
> Signed-off-by: Kalle Valo <kv...@codeaurora.org>

Tested-by: Stefan Lippers-Hollmann <s....@gmx.de>

[...]

I've been able to test v13 of this patch, including the changes regarding 
removing ath10k_leds_start() and moving the ath10k_wmi_gpio_config() call
into ath10k_leds_set_brightness_blocking() as raised by Sebastian 
Gottschall, on a ZyXEL NBG6817 (using two QCA9984 wlan cards and firmware 
10.4-3.5.3-00053) running OpenWrt/ master r6644-eda27d7557 (ipq8065, 
kernel 4.9.92 with backports wt-2017-11-01-0-gfe248fc2c180/ 
v4.14-rc2-1-31-g86cf0e5d).

/sys/class/leds/ath10k-phy0/ and /sys/class/leds/ath10k-phy1/ are
registered correctly and the white wlan LEDs connected to the ath10k 
GPIOs are now working as designed (controlled via phy0tpt/ phy1tpt).

Thanks a lot to everyone involved!

Regards
        Stefan Lippers-Hollmann

Reply via email to