On Tue, Mar 05, 2002 at 06:31:55PM -0700, James Rich wrote: > I have a functioning version of scs2pdf. The diff is quite large so I > didn't include it here. I don't know how to get it to compile with > ./configure; make; make install so I'll leave that to the autoconf people > here. I just copied to build commands of scs2ascii.c and ran them by > hand.
in Makefile.am, add scs2pdf under `bin_PROGRAMS=', and name the .c sources for it under a new section `scs2pdf_SOURCES='. Reconfigure and make and it should work. > > Notes: > 1. It only produces one page so far, even though you may have many pages > of output. The text just runs off the end of the page. > > 2. The PDF is always 8.5x11 in., no landscape or other page sizes. > > 3. It always uses Courier 10 point font (not 10 cpi). > > 4. If your output is longer than the page is wide it just prints off the > edge of the page. > > 5. But it does work. Use lp5250d with the outputcommand argument set to > scs2pdf > outfile.pdf to save the file somewhere. > > The diff can be downloaded from: > > http://www.eaerich.com/scs2pdf.c.diff > > or just get the C source: > > http://www.eaerich.com/scs2pdf.c > > James Rich > [EMAIL PROTECTED] > -Jay 'Eraserhead' Felice _______________________________________________ This is the Linux 5250 Development Project (LINUX5250) mailing list To post a message email: [EMAIL PROTECTED] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/cgi-bin/listinfo/linux5250 or email: [EMAIL PROTECTED] Before posting, please take a moment to review the archives at http://archive.midrange.com/linux5250.
