On 17-Nov-2003 Richard Smith wrote: > Niki Waibel wrote: > >> >> ~ # setserial /dev/tts/1 -a >> /dev/tts/1, Line 1, UART: unknown, Port: 0x02f8, IRQ: 3 >> Baud_base: 115200, close_delay: 500, divisor: 0 >> closing_wait: 30000 >> Flags: spd_normal skip_test >> === > > Are you sure setserial acutally reads the info from the device or is it > just showing you what the current settings of the device should be? > > Ah.. Never mind I just looked at the man page and answered my question. > > from the man page > "It is important to note that setserial merely tells the Linux kernel > where it should expect to find the I/O port and IRQ lines of a > particular serial port. It does *not* configure the hardware....." > > So I'm guessing the 2nd serial device isn't enabled.
so it is. it is done in src/superio/via/vt1211/setup_serial.inc but there are too many fancy values :) niki _______________________________________________ Linuxbios mailing list [EMAIL PROTECTED] http://www.clustermatic.org/mailman/listinfo/linuxbios
