Perhaps it'll help if I'm more specific.  It appears some changes have
been made to the via/epia tree and the southbridge doesn't seem to be
working like it should (or used to).

Using a filo payload (that works on a previous version of LinuxBIOS), I
now get the following:

LinuxBIOS-1.1.7.0Fallback Wed Mar  9 16:54:36 MST 2005 starting...
87 is the comm register
SMBus controller enabled
vt8601 init starting
00000000 is the north
1106 0601
0120d4 is the computed timing
NOP
PRECHARGE
DUMMY READS
CBR
MRS
NORMAL
set ref. rate
enable multi-page open
Slot 00 is SDRAM 10000000 bytes
0100 is the chip size
000e is the MA type
Slot 01 is empty
Slot 02 is empty
Slot 03 is empty
vt8601 done
Copying LinuxBIOS to ram.
Jumping to LinuxBIOS.
FILO version 0.4.2 ([EMAIL PROTECTED]) Tue Mar  8 15:01:09 MST 2005
collect_linuxbios_info: Searching for LinuxBIOS tables...
find_lb_table: Found canidate at: 00000500
find_lb_table: header checksum o.k.
find_lb_table: table checksum o.k.
find_lb_table: record count o.k.
collect_linuxbios_info: Found LinuxBIOS table at: 00000500
convert_memmap: 0x00000000000000 0x00000000000b7c 16
convert_memmap: 0x00000000000b7c 0x000000000ef484 1
convert_memmap: 0x000000000f0000 0x00000000000400 16
convert_memmap: 0x000000000f0400 0x0000000ff0fc00 1
Press <Enter> for default boot, or <Esc> for boot prompt... timed out
boot: hda1:/phase1.epia console=tty0 console=ttyS0,19200
find_ide_controller: found PCI IDE controller 1106:0571 prog_if=0x8f
find_ide_controller: primary channel: native PCI mode
find_ide_controller: cmd_base=0x0 ctrl_base=0x0
ide_software_reset: Waiting for ide0 to become ready for reset... ok
IDE time out
No drive detected on IDE channel 0


(Both primary and fallback payloads are the same)

What could be going wrong?

-Josiah England

_______________________________________________
Linuxbios mailing list
Linuxbios@clustermatic.org
http://www.clustermatic.org/mailman/listinfo/linuxbios

Reply via email to