Hi Claudiu, > Does this show up on a half duplex (100Mb/s) link?
In my testsetup I always used 1GBit Ethernet connections, so no 100MBit tested yet. Should I do so ? > Could you provide following for the gianfar interface, on your setup: sure: > # ethtool ethX root@Bluse-home:~# ethtool eth0 Settings for eth0: Supported ports: [ ] Supported link modes: 1000baseT/Full Supported pause frame use: No Supports auto-negotiation: No Advertised link modes: 1000baseT/Full Advertised pause frame use: No Advertised auto-negotiation: No Speed: 1000Mb/s Duplex: Full Port: MII PHYAD: 0 Transceiver: external Auto-negotiation: on Current message level: 0x0000003f (63) drv probe link timer ifdown ifup Link detected: yes > and > # ethtool -d ethX | grep 500 > root@Bluse-home:~# ethtool -d eth0 | grep 500 0x0500: 00 00 00 3f 00 00 72 05 40 60 50 60 00 a1 f0 37 > Is there any other indication before this Oops? Like a tx timeout WARN? > Nothing there about any timeout. Greetings Thomas > Thanks, > Claudiu > > > _______________________________________________ > Linuxppc-dev mailing list > Linuxppc-dev@lists.ozlabs.org > https://lists.ozlabs.org/listinfo/linuxppc-dev _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@lists.ozlabs.org https://lists.ozlabs.org/listinfo/linuxppc-dev