On 10/11/2013 11:59 AM, Thomas Hühn wrote:
Hi Claudiu,
Does this show up on a half duplex (100Mb/s) link?
In my testsetup I always used 1GBit Ethernet connections, so no 100MBit tested
yet.
Should I do so ?
Could you provide following for the gianfar interface, on your setup:
sure:
# ethtool ethX
root@Bluse-home:~# ethtool eth0
Settings for eth0:
Supported ports: [ ]
Supported link modes: 1000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: No
Advertised link modes: 1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: No
Speed: 1000Mb/s
Duplex: Full
Port: MII
PHYAD: 0
Transceiver: external
Auto-negotiation: on
Current message level: 0x0000003f (63)
drv probe link timer ifdown ifup
Link detected: yes
and
# ethtool -d ethX | grep 500
root@Bluse-home:~# ethtool -d eth0 | grep 500
0x0500: 00 00 00 3f 00 00 72 05 40 60 50 60 00 a1 f0 37
Is there any other indication before this Oops? Like a tx timeout WARN?
Nothing there about any timeout.
Please try the following patch:
http://patchwork.ozlabs.org/patch/283235/
It should help with your issue.
claudiu
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev
