> We actually have one of these - and the H/W engineer is NOT > happy at all. Apparently, it is NOT that stable for single > step operations, and does NOT give a consistent view of the > All the internal registers and/or the ability to view all > the registers natively! > > I am hoping for one that is more consistent and aware (and stable).
Just to add my 2 cents, I had problems with the BDI-2000 as well. The unit I got from Abatron had a hardware problem (the ethernet controller would sometimes reset when the BDI initialised the target PPC processor). Their French distributor agreed to replace it after making sure it was indeed a hardware issue (they seem to assume end-users have a negative IQ and are unable to diagnose such a hardware problem themselves). The new unit works *mostly* fine. No debugging issue (not that I use it that much anyway, now that the board boots Linux), but still a flash programming issue. Programming the target parallel NOR flash works in slow JTAG mode, but not in faster mode using the internal workspace. I reported the problem several months ago and still haven't received any solution. It might not be Abatron's fault, the French distributor might not have reported the problem to them. Abatron people speak German only, and will not respond to e-mails written in English (nor will they talk to you on the phone, they just hang up). The BDI-2000 is a nice product, but has a few bugs, is IMHO overprized and has one of the worst support service I've had to deal with. Laurent Pinchart _______________________________________________ Linuxppc-embedded mailing list [email protected] https://ozlabs.org/mailman/listinfo/linuxppc-embedded
