The saga continues. Well some of the problems I had was of the brown paperbag over head kind of error but now I can boot and run a version checked out a few hours ago.
But the ethernet reporting of the line is wrong. This is a problem with the printout only as the function is right. The 100Mb full duplex is reported to be 10Mb half and vise verse. I have not run the walnut hardware for some time but I still have a quite severe problem with ethernet in 10Mb. What happens is this if I connect to a 3com 10Mb hub that is connected to the office net (cisco switch) the switch turns off the port after some time mostly when I run apt-get. Since the walnut card is never directly connected to the switch this must be some logical error in packets probably the intergap time is to small that is the only thing I can think of as the switch only care about the ethernet layer. This problem could maybee exist if I directly connect to the switch I have not done that and no I can not test this easy as I don't control the switch and now only have 1 working port in that room and it is really needed. -- Kenneth Johansson Ericsson Business Innovation AB Tel: +46 8 404 71 83 Vider?gatan 3 Fax: +46 8 404 72 72 164 80 Stockholm kenneth.johansson at inn.ericsson.se ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
