Hi, I was some experience for similar problem on past time. It was happened on kernel porting process (to other board). For my problem, It caused by ppc_md.calibrate_decr = todc_calibrate_decr; . i forgot to initialize external real time clock( so rtc was stopped). that means it does not work and stop on same point.... If you use another calibrate_decr (based on bus clock or another clock), maybe it caused by other problem...
Best Regards, Yuji Nishimura - Tokyo, Japan. emanuel stiebler wrote: > > Hi, > I have a board which is close to Sandpoints mpc8245 cpu board. > (using internal DUARTs, EPIC_MODE_SERIAL) > > Trying to get it working, I got until: > > Filename 'pImage'. > Load address: 0x1000000 > Loading: ################################T ###################T > ############## > ###T > ############################################################## > ##T ######################### > done > Bytes transferred = 801369 (c3a59 hex) > => bootm 1000000 > ## Booting image at 01000000 ... > Image Name: Linux-2.4.20 > Created: 2003-03-04 23:57:29 UTC > Image Type: PowerPC Linux Kernel Image (gzip compressed) > Data Size: 801305 Bytes = 782 kB = 0 MB > Load Address: 00000000 > Entry Point: 00000000 > Verifying Checksum ... OK > Uncompressing Kernel Image ... OK > id mach(): done > MMU:enter > MMU:hw init > MMU:mapin > MMU:mapin_ram done > MMU:setio > MMU:exit > setup_arch: enter > setup_arch: bootmem > mpc10x:enter > mpc10x:exit > arch: exit > openpic: enter > openpic: timer > openpic: external > openpic: spurious > openpic: exit > > > then it stops. Any idea what it is waiting for ? > > And another question, I don't see any of the "printk ()" outputs I put > in the code, did I missed a flag ? > > Cheers & thanks for any help > > > > ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
