Hi all, I have got RPX-CLLF target , I'm trying to port PPC Linux , I made tftp,nfs and DHCP setup and I could able to load the kernel using tftp , the problem is I couldn't able to run the kernel .
Here is the Log: MPC8xx PlanetCore Boot Loader v2.00 Copyright 2001 Embedded Planet. All rights reserved. DRAM available size = 16 MB wvCV DRAM OK Autoboot in 2 seconds. ESC to abort, SPACE or ENTER to go. Autoboot aborted. >set Baud = 9600 Multiplier (Clock multiplier) = 5 Board = CLLF Revision = BW31 Processor = 855 Variant = T DRam (Mbytes onboard dram) = 16 Cols (Columns onboard dram) = 10 NVRam (Kbytes onboard nvram) = 512 Sttm (Degrees C*10) = 0 Twirl = Y ICache = N SYPCR = FFFF0689 RAMtest = Y RestoreCE (Cannot go to ram if set) = N SerPort (Serial port to use for monitor) = SMC1 SerOut (Serial output of loader) = Always RS232 (Enable rs232 drivers) = Y IP = 192.168.222.200 Target = 192.168.222.208 File = vmlinux ENET = 0010EC002D1E DefaultENET = ENET TftpRAM = High Start = 400000 Format = NetBin Autoboot = Confirm >t Load using tftp via Ethernet Enter server IP address <192.168.222.208> : Enter server filename <vmlinux> : Enter (B)inary or (S)record input mode <B> : Enter address offset : <00400000 hex> : .512.1024..2048... Total bytes = 1839078 in 9948811 uSecs Loaded addresses 00400000 through 005C0FE5. Start address = 00400000 >g [Go 00400000] There after no responce from the target... Anybody can help ? Thanks in advance Regards, KP ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
