Thank you sam I made Binary Image and I could boot my target. Rgards, KP
-----Original Message----- From: [EMAIL PROTECTED] [mailto:owner-linuxppc-embedded at lists.linuxppc.org]On Behalf Of Song Sam Sent: Saturday, May 15, 2004 12:03 AM To: Prabhakar Kalasani; linuxppc-embedded at lists.linuxppc.org Subject: Re: RPX-CLLF porting Prabhakar Kalasani <kalasani at sena.com> wrote: > I have got RPX-CLLF target , I'm trying to port PPC Linux , I made > tftp,nfs and DHCP setup and I could able to load the kernel using tftp > , the problem is I couldn't able to run the kernel . > File = > vmlinux > ENET = > 0010EC002D1E > DefaultENET = > ENET > TftpRAM = > High > Start = > 400000 > Format = > NetBin > Enter server filename <vmlinux> : > Enter (B)inary or (S)record input mode <B> : > Enter address offset : <00400000 hex> : > .512.1024..2048... > Total bytes = 1839078 in 9948811 uSecs Pls check your LINUX kernel format.As you set in the configuation,image format is NetBin.But it seemed that you downloaded ELF kernel.Pls try zImage.embedded rather than vmlinux. Best regards, Sam ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
