Mark, Thanks, I do not have the kernel source from the development tree. I will download it. However, it appears that the Sandpoint boards supported in U-Boot are for the 8240 and the 8245. I guess that is where my work will begin.
Thanks again, Dan -----Original Message----- From: Mark A. Greer [mailto:[EMAIL PROTECTED] Sent: Thursday, January 23, 2003 6:17 PM To: Dan Douglass Cc: linuxppc-embedded at lists.linuxppc.org Subject: Re: Sandpoint X3 with MPC755 Dan Douglass wrote: >Mark, > >Can you give me some insight as to where it is located then? I do not see >support for it in U-Boot nor the kernel version I mentioned (2.4.21). > > Dan, You must not be looking in the right place (for kernel support). Sandpoint X3 support is in the linuxppc_2_4_devel tree. You can clone the bk repository at bk://ppc.bkbits.net/linuxppc_2_4_devel. As far as U-Boot, I don't use it but I thought it ran on the sandpoint (at least, I think PPCBoot used to). DINK comes on the sandpoint & the zImage.sandpoint produced when you build the kernel (make zImage) will run on recent versions of that firmware. If you need more help getting the source, try looking at http://penguinppc.org/dev/kernel.shtml Note that there are currently a few problems with IDE in that tree right now. If you're looking for a truly supported version, go to http://www.mvista.com and/or [I believe] http://www.denx.de. There are probably others as well. Mark ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
