Thanks for the reply Dan. Just before I got your mail,
I was going through the fcc ethernet driver from
mvista and I noticed the BCSR hack code to make the
PHY work on an EP8260. I went back to the manual for
the EP8280 and realized that they did something
similar on this board, just as you guessed. I will add
code to manage the PHY using these bits later.
Meanwhile, this board also has BCSR bits to control
enabling and powering on the PHY. I was able to add a
bit of code to my ethernet driver and I can now see
the blinking lights on the ethernet port, similar to
the ones I see during tftp transfers from the boot
monitors. Interestingly, the boot monitor turns off
all the PHYs while the ethernet port is not being
access from the boot monitor. I fail to understand the
reasoning.
Anyways, I am able to enable and power the PHY device
and it looks like the port is seeing ethernet
activity. But my driver doesn't work and complains
about a TX timeout. I am sure I am missing something.
Can you suggest something that I could try?
Thank you.
--- Dan Malek <dan at embeddededge.com> wrote:
>
> On Oct 12, 2004, at 5:02 PM, annamaya wrote:
>
> > I am now trying to do an NFS mount of the root
> file
> > system. Looks like the EP8280 uses LXT971A PHY
> device.
>
> I have one of their first 8260 boards that I used to
> do
> the initial Linux port long ago. At that time, they
> had
> some weird CPLD implementation of MDIO that I could
> never get to work properly. Not a bad idea, just
> didn't
> seem to be implemented properly. I know they have
> done a second revision of this board, and I suspect
> the 8280 is just a glue into the same location
> design.
>
> With that board you should have received sufficient
> information to determine what to do, although they
> have always been quite secretive about releasing
> enough information to successfully write software.
>
> In the interim, just compile the driver without any
> MDIO control, hack the call to fcc_restart() at the
> end of init_fcc_startup() to just force half or full
> duplex (0 or 1) based upon the switch you are using.
>
>
> Good Luck.
>
>
> -- Dan
>
>
__________________________________
Do you Yahoo!?
Y! Messenger - Communicate in real time. Download now.
http://messenger.yahoo.com
