HI, We've run into a bit of an odd problem and we are not sure where to go and look for the cause.
We have some 440EPx based hardware with two GIG-Ethernet ports using RGMII and 2x ET1011C PHY's. Problem is that eth1 will only initialise correctly (i.e. receive and transmit) if eth0 has a link. Eth0 always work OK, regardless of eth1 status. Eth1 will work OK if eth0 has a link (i.e. initialised) at time of setup. Once initialised, eth0 status is irrelevant. All this is during Linux boot process. Any ideas? We can access PHY registers via u-boot (mii commands). Same 1Gig link speed is used on both ports. Linux kernel is 2.6.19. Regards Jan Reyneke _________________________________________________________________ Can you see your house from the sky? Try Live Search Maps http://maps.live.com _______________________________________________ Linuxppc-embedded mailing list Linuxppc-embedded@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-embedded
