On Wed, 19 Sep 2007 13:54:35 +0000 "- Reyneke" <[EMAIL PROTECTED]> wrote:
> HI, > > We've run into a bit of an odd problem and we are not sure where to go and > look for the cause. > > We have some 440EPx based hardware with two GIG-Ethernet ports using RGMII > and 2x ET1011C PHY's. Problem is that eth1 will only initialise correctly > (i.e. receive and transmit) if eth0 has a link. Eth0 always work OK, > regardless of eth1 status. Eth1 will work OK if eth0 has a link (i.e. > initialised) at time of setup. Once initialised, eth0 status is irrelevant. > All this is during Linux boot process. > > Any ideas? > > We can access PHY registers via u-boot (mii commands). Same 1Gig link speed > is used on both ports. Linux kernel is 2.6.19. Where did you get your kernel from? 2.6.19 doesn't have any 440EPx support in it. Maybe you should ask your vendor. josh _______________________________________________ Linuxppc-embedded mailing list Linuxppc-embedded@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-embedded
