On Dec 9, 2007 1:18 AM, Grant Likely <[EMAIL PROTECTED]> wrote: > On 12/8/07, Jean-Samuel Chenard <[EMAIL PROTECTED]> wrote: > > Thanks to the valuable information provided by this discussion group and > > particularly by Grant Likely from Secret Lab Technologies, I was able to > > setup and run Linux 2.6 on my ML-310 development platform. > > Congratulations. If you had to make any changes to get it to work > then please send me your patches.
Thank you for the quick reply. I will directly update Secret Lab's Wiki pages. Those pages are the ones that got me going really quickly, so I will add a few of my observations directly on your pages so everyone can benefit. I ended up using Secret Lab's GIT tree as my source archive, so I'll let you know if I need to fix some code. > You'll have to go back into the mailing list archives to find a patch > for adding PCI support for a Virtex platform. I don't have any of > that in my tree. It probably only exists for the 2.4 kernel. You'll > need to port forward to use it on 2.6 (I'm more than willing to help > you with this) Hmmm... I'm not really ready to invest that much time into the PCI for ML-310. My real target is the control FPGA on a BEE2 box (http://bee2.eecs.berkeley.edu) and on that particular setup, the control FPGA is directly connected to an LXT971A Ethernet PHY, so I'll use the ethernet MAC from Xilinx. I use the ML-310 as a stepping stone for quickly prototyping some of my FPGA changes since the VirtexII-Pro in the ML-310 is much smaller and doesn't eat up all my workstation resources when re-compiling the FPGA. > However, word of warning. The Xilinx PCI bridge is badly broken. > Xilinx is not supporting the PCI core and it is missing the ability to > do certain types of transfers. Last I heard, Xilinx has no plans to > fix their PCI core either. Ok, its nice to know the status of that module. Too bad Xilinx is dropping the support for it. In that case, it would probably be more beneficial for all to adapt an "open core" project such as this PCI bridge: http://www.opencores.org/projects.cgi/web/pci/home Along with the help of an OPB to Wishbone wrapper like that one: http://www.opencores.org/projects.cgi/web/opb_wb_wrapper/overview With some work (and ideally some PCI expertise) one could get an open implementation of a PCI bridge that can integrate in the Xilinx EDK flow and could be repaired or adapted as time goes... I am a complete newbie to PCI, so I'll leave that to some willing "hacker". I'll continue on my quest to run Linux 2.6 on the BEE2 control FPGA. There is no PCI bus involved in that architecture. Just raw buses and a sea of FPGA logic. Regards, Jean-Samuel -- Integrated Microsystems Laboratory McGill University, Montréal, QC, CANADA Web Page: http://chaos.ece.mcgill.ca _______________________________________________ Linuxppc-embedded mailing list Linuxppc-embedded@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-embedded
