Joch, Thanks, apparently I had a conditional that was not matching up around that call. So now that I 'am' calling the of_platform_bus_probe(). I can see all the probe functions getting called. Thank you very much.
Next question, I can see that 'quick' mods I have made to the Marvell driver are indeed matching up with the device ID that the Freescale MII device is pulling back from my 'National' part. <I'll make a real phy driver once I get this working>. I.e. I can see the phy_probe get called when this Id is registered. You can see the extra debug messages above the National DP83865 device registration, and the probe returns 0 for success I assume. <err = 0>. I am still getting the "IP-Config: No network devices" error before the NFS boot tries to take place. BootLog: RWM DEBUG, uec_mdio_init:278 RWM DEBUG, uec_mdio_probe:145 UCC Ethernet Controller MII Bus: probed UCC Ethernet Controller MII Bus: Registered ucc_geth: QE UCC Gigabit Ethernet Controller Marvell 88E1101: Registered new driver Marvell 88E1112: Registered new driver Marvell 88E1111: Registered new driver RWM DEBUG: phy_probe:635 RWM DEBUG: phy_probe:663 err = 0 National DP83865: Registered new driver Marvell 88E1145: Registered new driver HDLC support module revision 1.21 usbmon: debugfs is not available mice: PS/2 mouse device common for all mice i2c /dev entries driver WDT driver for MPC83xx initialized. mode:reset timeout=65535 (16 seconds) usbcore: registered new interface driver usbhid drivers/hid/usbhid/hid-core.c: v2.6:USB HID core driver TCP cubic registered NET: Registered protocol family 1 NET: Registered protocol family 17 lec.c: Dec 18 2007 15:30:33 initialized mpc.c: Dec 18 2007 15:30:31 initialized IP-Config: No network devices available. .... NFS boot fails -Russ > -----Original Message----- > From: Jochen Friedrich [mailto:[EMAIL PROTECTED] > Sent: Monday, January 07, 2008 3:18 AM > To: [EMAIL PROTECTED] > Cc: linuxppc-embedded@ozlabs.org > Subject: Re: 83xx, ucc_geth, kernel 2.6.23, IP-Config: No network devices > > Hi Russell, > > > I would appear all the appropriate entries are in the .dts file > > for each the different parts (mdio, ucc_geth, ucc_geth_mdio, phy0). > > > > And yet still no probe functions get called for any of those drivers? > > Do you export the subtree using of_platform_bus_probe()? > > Thanks, > Jochen _______________________________________________ Linuxppc-embedded mailing list Linuxppc-embedded@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-embedded
