On Tue, Apr 15, 2008 at 7:40 PM, rodolfo <[EMAIL PROTECTED]> wrote: > Hi Grant likely, > > I got kernel 2.6.20 from kernel.org and I want boot it on XUP Virtex II Pro
This is an old kernel. Use a current kernel. > University board. > I edited the Makefile putting: > ARCH? = ppc > CROSS_COMPILE? = ppc_4xx- > But I can't see anything about SystemACE driver on make menuconfig from > this Kernel. How can I add SystemACE controler? Its in the block device menu > I compiled the kernel repeatedly generating a file zImage.elf. I used this > file with the genace.tcl from Xilinx and this opt file: > -jprog > -board user > -target ppc_hw > -hw implementation/download.bit > -elf zImage.elf > -configdevice devicenr 1 idcode 0x1127e093 irlength 14 partname xc2vp30 > -debugdevice devicenr 1 cpunr 1 > -ace system.ace > > to generated ace file and put it in FAT16 partition of CF card, like a lot > of references in web. But it doesn't works! > Which IP cores must be present in my project of the EDK? > Still speaking in the EDK Did i have to mark bram with ppc_405_0_bootloop? > Did I have to mark bram whit any software project? - Did you generate an xparameters_ml40x.h in edk and copy it into the kernel tree? - you need either a uart16550 or a uartlite for the console - Make sure the matching serial driver is compiled into the kernel - Make sure console support is enabled for the serial driver - Make sure your kernel boot parameters include 'console=ttyS0,115200' for uart16550 or 'console=ttyUL0' for uartlite. Cheers, g. -- Grant Likely, B.Sc., P.Eng. Secret Lab Technologies Ltd. _______________________________________________ Linuxppc-embedded mailing list Linuxppc-embedded@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-embedded
