Hi, The mark of BRAM is good at bootloop. Priority is given to specified initial pc if -start_address is specified by an opt file. Before starting a Linux kernel, can TestApp_Memory or a TestApp_Peripheral program be started from CF?
The opt file which I am using is as follows. -jprog -hw implementation/download.bit -ace cfboot.ace -board ml405 -target ppc_hw -elf zImage.elf -start_address 0x00400000 Best Regards, Yoshio Kashiwagi - Nissin Systems > Hi Grant likely, > > I got kernel 2.6.20 from kernel.org and I want boot it on XUP Virtex II Pro > University board. > I edited the Makefile putting: > ARCH? = ppc > CROSS_COMPILE? = ppc_4xx- > But I can't see anything about SystemACE driver on make menuconfig from > this Kernel. How can I add SystemACE controler? > > I compiled the kernel repeatedly generating a file zImage.elf. I used this > file with the genace.tcl from Xilinx and this opt file: > -jprog > -board user > -target ppc_hw > -hw implementation/download.bit > -elf zImage.elf > -configdevice devicenr 1 idcode 0x1127e093 irlength 14 partname xc2vp30 > -debugdevice devicenr 1 cpunr 1 > -ace system.ace > > to generated ace file and put it in FAT16 partition of CF card, like a lot > of references in web. But it doesn't works! > Which IP cores must be present in my project of the EDK? > Still speaking in the EDK Did i have to mark bram with ppc_405_0_ bootloop? > Did I have to mark bram whit any software project? > > My work in with Linux on Virtex don't work. I am almost dropping... > > Thanks!! _______________________________________________ Linuxppc-embedded mailing list Linuxppc-embedded@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-embedded
