Hi Georg,
Can you post linux bootup message where its says PHY is detected at
paticular address, and check with your hardware what is actual address
of PHY. Also I would like to know the configuration of your hardware
whether its configured of 10MBPS OR 100MBPS.
------------------------------------------------------------------------------------------
--
Neeraj Garg
Message: 3
Date: Mon, 08 Sep 2008 18:29:53 +0200
From: Georg Schardt <[EMAIL PROTECTED]>
Subject: EDK10.1 and emaclite
To: linuxppc-embedded@ozlabs.org
Message-ID: <[EMAIL PROTECTED]>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed
Hi all,
im trying to use the emaclite core which comes with the EDK10.1 with the
2.6.26 kernel from git.xilinx.com on virtex4fx12 minimodul. the emac is
detect by the kernel:
xilinx_emaclite xilinx_emaclite.0: MAC address is now 2: 0: 0: 0: 0: 0
xilinx_emaclite xilinx_emaclite.0: using fifo mode.
xilinx_emaclite xilinx_emaclite.0: Xilinx EMACLite at 0x81000000 mapped
to 0xC5060000, irq=0
i can change the mac-address with ifconfig and i can give an ip-address
to the device,
but a ping is not possible and arp is not working. i think that the phy
is not working right.
has someone others the same problem ? what can i changed ? i have tried
out all possible phy driver in the linux kernel
a setup with the lltemac is working fine, but i want to use the emaclite
thanks
regards
georg
_______________________________________________
Linuxppc-embedded mailing list
Linuxppc-embedded@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-embedded
