On 10/14/2011 1:50 PM, Nenhum_de_Nos wrote:
On Fri, October 14, 2011 14:41, Vaughn L. Reid III wrote:

On 10/14/2011 1:19 PM, Jim Pingle wrote:
If you upgrade from x86 to x64.  Can you do the upgrade remotely from
2.0 release x86 using the gui?  Or, is it necessary to do the upgrade
from the pfsense console command line interface?
It can be done remotely, but ...

Also, when Seth mentioned "hard reboot," is he describing doing an init
6 from the command prompt or physically pulling the plug on the unit?
Someone will need to pull the plug or cycle power manually. If you have
IPMI/DRAC/etc then you can reset it that way.

Problem is that you now have a 64-bit reboot binary on a 32-bit system,
and it can't be executed. Also sometimes other bits freak out even if it
starts the reboot process. (We try to preserve a 32-bit reboot binary
but apparently that isn't enough).

Jim
_______________________________________________
List mailing list
[email protected]
http://lists.pfsense.org/mailman/listinfo/list
Thanks!  That clears that up for me.

Now....... if only there were a listing somewhere of what addons are
available for x86 versus x64 versus embedded   :-)

Have a good weekend everyone.
Vaughn,

have you figured out how to do it remotely ?

please share :)

matheus

I haven't tried yet. Since I don't have drac or ipmi or a metered IP capable PDU on the firewalls I want to move to x64, I think I'll need to go on-site to see what happens. Luckily, it's only about 15 blocks from me. I'll think about doing this in the next week or two. Once it happens, I'll share my experience on here.

_______________________________________________
List mailing list
[email protected]
http://lists.pfsense.org/mailman/listinfo/list

Reply via email to