Am 25.01.2012 16:26, schrieb Moshe Katz:
Try using "Source: * (any)" instead of "Source: WLAN Net". It will only apply to WLAN traffic anyway because of which interface it applies to.

It would be helpful for you to send the screenshot again WITH the left-most column - the icons OUTSIDE the table. Make sure your rules are actually "block" rules (red icons) and that they are enabled.

I'm sorry if this sounds like a stupid question but did you make sure your IP address is not the one that is allowed through in the first rules?

Moshe

------------------------------
Moshe Katz
-- [email protected] <mailto:[email protected]>
-- +1(301)867-3732 <tel:%2B1%28301%29867-3732>



2012/1/25 Jürgen Echter <[email protected] <mailto:[email protected]>>

    Am 24.01.2012 12:58, schrieb Matthias May:

        Jürgen Echter wrote:

            Hi,

            maybe i'm doing something wrong.

            i have 3 interfaces, one for wan, one for lan and one for
            wlan.

            i don't want that wlan users have access to my lan.

            so i tell the firewall rule on the LAN interface to block
            everything from WLAN subnet, but i'm still able to receive
            different webpages hosted on the LAN.

            also i tried to tell the WLAN interface to block
            everything what has my LAN as destination, same effect.

            what's wrong?

            greets

            juergen
            _______________________________________________
            List mailing list
            [email protected] <mailto:[email protected]>
            http://lists.pfsense.org/mailman/listinfo/list


        Firwall rules go to the interface on which traffic is received.
        So if you want to block traffic from the WLAN interface to the
        LAN interface, then the rule has to go to the WLAN interface.
        Rules are processes from top to bottom and if a rule catches
        the rest below is no longer considered.
        Meaning if you have an allow rule above your block rule, the
        allow rule will always catch.
        Put your block rules all the way to the top.

        If that doesn't help, send a screenshot of your rules.
        (Overview, not the configuration of the rule itself).

        Greetings
        Matthias May
        _______________________________________________
        List mailing list
        [email protected] <mailto:[email protected]>
        http://lists.pfsense.org/mailman/listinfo/list


    ok, here's a screenshot from my rules.

    i want to block / reject access from wlan to lan.

    if i try from a box in the wlan to access a webpage from lan it
    just works. thats what i don't want :)

    greets.

    _______________________________________________
    List mailing list
    [email protected] <mailto:[email protected]>
    http://lists.pfsense.org/mailman/listinfo/list



_______________________________________________
List mailing list
[email protected]
http://lists.pfsense.org/mailman/listinfo/list
Hi,

yes i'm sure it's not the one i added there. The IP i added is reserved for my little eeePC.

imho if i have wlan subnet as source it should be blocked, because im coming from wlan subnet.

greets

juergen
_______________________________________________
List mailing list
[email protected]
http://lists.pfsense.org/mailman/listinfo/list

Reply via email to