I have tested with a VPN on the Wan first then restarted racoon on both local 
and remote sites. The VPN tunnel connects and I can route over it fine / 
contact devices both ways.

I then change the Ipsec Interface to the IP alias on the local machine and 
changing the remote gateway to the "new" Ip address on the remote gateway 
settings.

Restart racoon again to be safe but then get the error:

"INFO: IPsec-SA request for 111.222.333.444 queued due to no phase1 found" in 
the log files.

I am sure Outbound NAT is correct. Is there anything else that needs setup or 
checked ?

Regards

From: [email protected] [mailto:[email protected]] On 
Behalf Of Gavin Will
Sent: 14 March 2012 13:36
To: pfSense support and discussion
Subject: Re: [pfSense] Problems with Virtual IP and IPsec VPN

Apologies. I have found the service under status / service.

Will try that now

Gavin


From: [email protected]<mailto:[email protected]> 
[mailto:[email protected]] On Behalf Of Gavin Will
Sent: 14 March 2012 13:35
To: [email protected]<mailto:[email protected]>; pfSense 
support and discussion
Subject: Re: [pfSense] Problems with Virtual IP and IPsec VPN

Thanks Adam for your input.

How can I restart the ipsec service? Is this just uncheck enable ipsec and then 
renable or is there a command I can run?

Regards

Gavin



From: [email protected]<mailto:[email protected]> 
[mailto:[email protected]] On Behalf Of Adam Piasecki
Sent: 14 March 2012 13:16
To: [email protected]<mailto:[email protected]>
Subject: Re: [pfSense] Problems with Virtual IP and IPsec VPN

On 3/14/2012 7:12 AM, Gavin Will wrote:

Hi there,

I have a BT infinity "fibre" (fibre to cabinet) connection with 5 static IP 
addresses.



I have added the 5 Ips as IP Alias and can get NAT to work on the virtual IP  
work and Outbound Nat to show it is coming from that IP alias from the local 
network (quick what is my ip test in google)



Setting up an IPSec VPN to another PFsense box (and selecting the Interface 
"myipalias" - not selecting wan)  i get the error "IPSEC-SA was queued due to 
no phase1 found"



http://doc.pfsense.org/index.php/IPsec_Troubleshooting hints at it being an 
issue on the remote side but other VPNs are connected fine.



Any ideas on this or is there a guide on IPSec with Virtual IP at all?



Many Thanks



Gavin

I would try making it work on the WAN first, after that works, change it to the 
virtual IP. I've never tried with Virtual IP's, but I've had this same error, 
usually it involves a config problem, triple check your configs, and restart 
IPSec on both sides.

Adam
_______________________________________________
List mailing list
[email protected]
http://lists.pfsense.org/mailman/listinfo/list

Reply via email to