I'm having problems w/ an Alix board w/ WiFi. Wifi was working on 2.0 release.
I wrote a new card to take it to 2.1 and WiFi worked until I enabled WPA &/or WPA2. At that point there is no SSID broadcast. When logging into the router under interface status I see the Wireless interface listed as down autoselect <hostap>. The only way I've found to correct his is to either default the router and set it up again, or disable WPA, change the mode from Access Point to Infrastructure, save, apply, and then back to AP. I haven't tried changing it to Adhoc. Some background on it. There is a bridge (Bridge0) which consists of Lan1=vr2, Lan2=vr1, and Wireless=ath0. It is assigned to LAN. WAN is VR0. LAN IP = 192.168.32.1 NM=255.255.255.0. WAN is currently a static IP on a /28 for testing. I've updated 2.1 to the newest version offered as of this morning. I've tried another card, and downloaded the firmware to write the card more than once. I've updated it to at least two different versions w/ the same results. Any suggestions? It appears I've run across a bug or incompatability w/ my hardware. _______________________________________________ List mailing list [email protected] http://lists.pfsense.org/mailman/listinfo/list
