I installed 2.1 on a SanDisk 4GB Ultra (200x) for use on an Alix board.
I configured the ethernet ports using the serial connection and then
left the connection and minicom running while I did more configuration
using the ethernet webConfigurator.
Every time I would make a change to the configuration, I get:
ad0: FAILURE - READ status=51<READY,DSC,ERROR> error=10<NID_NOT_FOUND>
LBA=78139
ad0: FAILURE - READ status=51<READY,DSC,ERROR> error=10<NID_NOT_FOUND>
LBA=78139
ad0: FAILURE - READ status=51<READY,DSC,ERROR> error=10<NID_NOT_FOUND>
LBA=78139
ad0: FAILURE - READ status=51<READY,DSC,ERROR> error=10<NID_NOT_FOUND>
LBA=78139
from the serial port. Even though it says FAILURE, the configuration was
retained. (Perhaps a power cycle will wipe it out. Will power cycle in a
minute and report here)
Can I do something to fix the problem, or eliminate the messages?
Perhaps the SanDisk Ultra is too fast? I picked it more for reliability
than speed. Perhaps it was not a good choice.
-----
On power cycle, there were some read errors:
...uhub0: 4 ports with 4 removable, self powered
ad0: FAILURE - READ status=51<READY,DSC,ERROR> error=10<NID_NOT_FOUND>
LBA=78139
ad0: FAILURE - READ status=51<READY,DSC,ERROR> error=10<NID_NOT_FOUND>
LBA=78139
Root mount waiting for: usbus1
uhub1: 4 ports with 4 removable, self powered
Trying to mount root from ufs:/dev/ufs/pfsense0
Configuring crash dumps...
Mounting filesystems...
Setting up memory disks... done.
Disabling APM onad0: FAILURE - SETFEATURES 0x85
status=51<READY,DSC,ERROR> erro>
/dev/ad0
...
but it seems all of my configuration information was retained.
Bob G
_______________________________________________
List mailing list
[email protected]
http://lists.pfsense.org/mailman/listinfo/list
