Just tracked my order and its suppose to arrive today. Can't wait! I went with the SSD they offer.

What drive project are you referring too? I don't understand your comment about get it now before it has any issues.

Brian

On 11/30/2014 3:07 PM, Walter Parker wrote:
If you are getting the Netgate kit, I'd suggest just getting the Intel m525 SSD that they offer. This is a modern SSD with wear leveling that keeps software like a squid cache from burning out the drive early. It will fit and work without having to build a custom cable and have to tape a drive to the case. IIRC, your setup is for a home network, so the amount of data that is likely to flow will be quite a bit below the SSD's limits. Also, I think the guys at Netgate picked that specific SSD from Intel because tested different SSD drives and found that the Intel drive worked well and has a good reputation for quality and longevity.

Why are you moving to the kit? If it because you want a small, low energy box that you can put in a corner and then forget about the hardware because it just works, then get the SSD and buy a backup device (SD card or SSD). Then in 5-10 years, if the SSD fails, you will have a replacement device on hand to replace the SSD that went out.

I suggest you get the SSD now. Before the SSD has any issues, Jim's new drive project will be complete and that one should last for life of the router.


Walter


On Sun, Nov 30, 2014 at 11:16 AM, Volker Kuhlmann <[email protected] <mailto:[email protected]>> wrote:

    On Fri 28 Nov 2014 13:56:32 NZDT +1300, Ryan Coleman wrote:

    > Have you considered a small 2.5" SATA HD for the machine? If
    > you're talking APU, of course. You can run it off 5V from the board
    > (I THINK?) I know there are SATA headers there.

    There is one SATA header on the board, and you get 5V power from a
    2-pin
    header close-by. Butcher a SATA power cable and solder something up
    yourself, or better buy the specially-made short SATA/power cable from
    PC Engines.

    A tip from PC Engines was to tape the disk under the lid, so all fits
    into the box. Might pay to check disk temperature afterwards. I
    noticed
    the latest revision of the APU board has a 2x3 test header missing to
    make more space for a 2.5" disk.

    I am about to try an SSD for pfsense and a 2.5" for the squid cache.
    Currently it all runs fine off a 2.5".

    I can't comment on the other hardware mentioned by the OP because of
    lack of experience.

    Volker

    --
    Volker Kuhlmann                 is list0570 with the domain in header.
    http://volker.top.geek.nz/     Please do not CC list postings to me.
    _______________________________________________
    List mailing list
    [email protected] <mailto:[email protected]>
    https://lists.pfsense.org/mailman/listinfo/list




--
The greatest dangers to liberty lurk in insidious encroachment by men of zeal, well-meaning but without understanding. -- Justice Louis D. Brandeis


_______________________________________________
List mailing list
[email protected]
https://lists.pfsense.org/mailman/listinfo/list

_______________________________________________
List mailing list
[email protected]
https://lists.pfsense.org/mailman/listinfo/list

Reply via email to